Haltech Haltuner A/F Monitor and Full Terminated Harness
#1
Full Member
Thread Starter
Join Date: Feb 2002
Location: Bay Area
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
Haltuner A/F Monitor and Full Terminated Harness
I'm going to use a Haltuner for a A/F monitor and would like to know where I can plug it into the E6K fully terminated harness or do I have to splice wires?
Thanks,
Matt
Thanks,
Matt
#2
Lives on the Forum
It's easier if you tap it off the O2 sensor and run it all the way back into the interior.  The majority of the O2 sensor signal wire is shielded, so to "crack" into the Haltech harness (wiring) would require cutting past this shield.
-Ted
-Ted
Thread
Thread Starter
Forum
Replies
Last Post
driftfcbuckey
The Bad & Fugly Members
10
12-02-15 05:48 PM
RPOdesign
New Member RX-7 Technical
5
08-27-15 11:42 PM