How do you wire up the factory fuel level sensor to the E8 in a FC? There is a blue and red wire from the fuel level sensor,isn't it the blue one that goes to the haltech? Do you use one of the aux inputs? And what do you have to change in the software? Tried searching but as usual I end up with nothing

 

I created a voltage divider and then used it in conjunction with a pressure sensor input on the Haltech. Setup my calibration from the fuel sender and then named it a fuel level in the
Racepak software.

I then bought the 4 channel generic input from Racepak when I ran out of inputs after upgrading to the sport 1000.