Haltech Emissions requirements and Haltech question
#1
Emissions requirements and Haltech question
I recently purchased a Haltech E6X for my FC. I however didnt think of the fact that I need to pass an emissions test yearly in my area. Do any of you with Haltechs pass emissions, and if so, do you have any problems? I will still be running the air pump and cat of course, but not sure what to do about the ACV, and other emissons equipment that are required. I do not need a visual check, as long as I pass the sniffer. Any input would be greatly appreciated, thanks.
#2
Moderator
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,778
Received 2,563 Likes
on
1,823 Posts
you could set the haltech to control the 2 acv solenoids as an rpm switch, to pass you just need to get the 2 vacuum lines on the acv (switching and relief) vacuum during the test, theoretically you could even not have the solenoids.
and you need to duplicate the factory mixture in the test loads and rpms (give or take), too lean and you get misfire, this sends hc's way high, too rich and co gets too high
and you need to duplicate the factory mixture in the test loads and rpms (give or take), too lean and you get misfire, this sends hc's way high, too rich and co gets too high
#4
Moderator
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,778
Received 2,563 Likes
on
1,823 Posts
it still needs the acv, the air pump air goes to the exhaust ports
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
09-01-15 10:46 PM