lupin

iTrader: (3)

My car all of a sudden stopped running, so I installed the new firmware(1.89) and got the new software. I now can get the car to start and run like crap for 4 seconds or so. My wideband will only read 1068 mv, and i just noticed a ecu diagnostic error. How should I go about diagnosing that error? https://www.rx7club.com/attachment.p...1&d=1266877573

lupin

iTrader: (3)

i don't wanna plague every thread of mine with double posts but I am going to state the obvious. Tomorrow I am gonna inspect my wideband. I was just wondering if there was a way to diagnose the error through the ecu?