just a heads up e8 users will find the REW to e11v2 diagram and also the ps1000 to s5 diagram and realise the colours dont match
if they try and reverse nut the colours out they will also find it doesnt quite work,, seems to me motor poles 1 and 4 have been screwed up in translation

this will make a pump that vibrates every few seconds but will not change position when viewed in the aux in logs

colours that work for me -
( note i am giving you the colours for the pump side, assuming you are replacing with generic connectors, and i am using AD3 for feedback input )
pump-
e8.............colours pump side of harness

brown/white...................white
brown.............................black
yellow/red........................blue
green/yellow..........................yellow

feedback
e8.............colours pump side of harness
orange /red ( AD input 3)..............yellow
thin orange ( 5V )......................blue
black ( earth ) ................black

 

scratch that.. the intermediate loom in this car was already creatively rewired ..
using a new loom then it does work out as you would reverse nut the colours


the correct e8 colours for aus delivered ecus-

pump-
e8.............colours pump side of harness

brown/white...................yellow
brown.............................blue
yellow/red........................black
green/yellow..........................white

feedback
e8.............colours pump side of harness
orange /red ( AD input 3)..............yellow
thin orange ( 5V )......................blue
black ( earth ) ................black