does anybody know the answer? will a map that was used with a e6k ecu work for the e6x?

 

there probably is an import function, there is in the e6k software for e6s maps...

 

Hell, I had to look for myself...
You can download the program from http://www.haltech.com/
Hit "Downloads"

Yes, you can Import maps from E6K and even down from an E6S!


-Ted

 

yah e6k will go to e6x

 

ok thanks guys for the replies

 

forgot, your ignition tooth/offset numbers will change because of the different reluctor

 

What do you need to change this to? Because I am running off of a map that was made for an E6K.

- Steiner

 

i dont know, just rezero it like you should have done when you loaded in the map

 

when you import the maps, it ONLY imports the maps for fuel and ignition

it will not import the SETTINGS for fuel/ignition...thus no cranky

it's a very stripped down import, your best bet is to import the maps....then download the e6k software, open a map, read the ignition settings/fuel settings and put them into your e6x map

 

wow that's a pain. I'll have to check my settings then when I go out to my car again. Cause right now I'm having the problem that it is saying I have a 1 bar map sensor when I have a 3 bar, and every time I change it, and supposedly lock it in, it will default back to 1 bar as soon as I go somewhere else in the software and come back. But I haven't tried this with it hooked up to the haltech. I need to get my electrical stuff done before I can hook it back up.

- Steiner