Haltech E6k maps
#3
Junior Member
Thread Starter
Join Date: Aug 2001
Location: Evans Ga.
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
I using 550cc primarys and 1600cc secondary
stage two street port. I think the fuel pressure is set at
40 psi. I'm also using Haltech closed loop 4 wire O2 sensor.
The ignition is the Jacob's pro pak system.
Also running low compression rotors 8:5:1
Boost is set at 13psi right now. But I plan on running the Boost
at 15-17 psi later. Turbo system is the T78 full exhaust
with a mid. pipe. The problem I have now is at idle the car
runs rich. really rich! And the idle is hunting.
The current maps on the haltech were set up for the stock engine
With the 550's and 1600's With the T78 system.
Not this new configuration. I do plan on having tuned on the dyno
but that's after break in. I need the maps just to have closer
to tune than it is now. Please reply A.S.A.P.
Thanks
Daniel
stage two street port. I think the fuel pressure is set at
40 psi. I'm also using Haltech closed loop 4 wire O2 sensor.
The ignition is the Jacob's pro pak system.
Also running low compression rotors 8:5:1
Boost is set at 13psi right now. But I plan on running the Boost
at 15-17 psi later. Turbo system is the T78 full exhaust
with a mid. pipe. The problem I have now is at idle the car
runs rich. really rich! And the idle is hunting.
The current maps on the haltech were set up for the stock engine
With the 550's and 1600's With the T78 system.
Not this new configuration. I do plan on having tuned on the dyno
but that's after break in. I need the maps just to have closer
to tune than it is now. Please reply A.S.A.P.
Thanks
Daniel
Thread
Thread Starter
Forum
Replies
Last Post
killerrx710
2nd Generation Specific (1986-1992)
1
09-24-15 10:57 PM