Ok so how do you get these to work ,I did use the pwm and the aux out to turn these on ,but for some reason they dont work ,i enabd them both of course seperately ,do i have to turn on the pull up for the 12volt supply and must i use a relay with the both of them or not,realty getting fustrated at this since the fan is also hooked up to the pwm and works perfectly.

 

The PWM wires DO NOT control the accesories directly, you need to use a relay inline of them to be able to run what ever you want to control, you can cause damage to the outputs if you do it that way!

Download the E6K manual off the Haltech website, it has diagrams on how to connect the different accesories with the PWMs.

 

Can i run a stock FC cluster tach with a pwn wire from a E6K? just wondering this also..Can't get my stock tack to work..

 

No, the tacho output on the haltech is the Aux.Out (green/black) wire, but, if you are using the toggle feature the aux.out is already taken up. But, you can run in Direct Fire spark mode and that frees up the Aux. Out.

 

I'M SALING A SET OF VOLK LE37 RIMS AND TIRES OFF OF MY SHOW CAR. THESE RIMS AND TIRES RETAIL AT $3800.00 FOR RIM AND TIRE. STEAL THEM FOR $2000.00 FIRM, LESS THAN 1 YEAR OLD CAR ONLY DRIVEN ONCE EVERY 2 WEEKS FULL TREAD STILL ON TIRES. THE FRONTS ARE 18X8.5 ON NITTO NT-555 235/40/18 AND REAR IS 18X9.5 275/35/18. PLEASE EMAIL ME AT DLANIER@OTCDSL.NET IF YOU ARE INTERESTED

 

On an FC, if you want to run the stock tach, just wire your PWM out(selected as Tacho output) to the Yellow/Blue wire on your drivers side harness next to your trailing coils. This is the Mechanics tacho wire, and it will have a bullet connector on it. Either cut and solder, or use a male bullet connector direct into the plug.