Haltech Does injector resistance matter w/ the haltech?
12-14-01, 01:45 AM
#1
Senior Member
Thread Starter
Join Date: Jun 2001
Location: san francisco,Ca
Posts: 327
Likes: 0
Received 0 Likes
on
0 Posts
Does injector resistance matter w/ the haltech?
I was wondering if high or low impeadance matters when it comes to the Haltech. I was hopeing that it doesn't because i wanted to use GSL-SE injectors for the primary and the 1600cc from K2RD for the secondaries. Would this be ok? If it is does the computer already know the resistance of the injectors? And if not do we have to set the resistance values ourselves? Please let me know. I'm about to get my haltech in the mail and want to know what i'm getting myself into. thanks in advance!!!
12-14-01, 03:52 AM
#2
inteligent extratarestril
Join Date: Mar 2001
Location: The Sunny B.O.P, New Zealand
Posts: 1,313
Likes: 0
Received 0 Likes
on
0 Posts
as long as you dont have a high impendence and a low impendence injector wired to the same injector driver wire - the ECU couldn't care less
if you are only running 4 injectors you have nothing to worry about, if you run 6 or 8 where you have double ups on injectors drivers then you have to make sure that both the injectors connected to that particurlar wire are of the similar resistance
if you are only running 4 injectors you have nothing to worry about, if you run 6 or 8 where you have double ups on injectors drivers then you have to make sure that both the injectors connected to that particurlar wire are of the similar resistance
