Haltech Can u use the stock FD Idle Air control valve on the E6K?

Reply Subscribe

Thread Tools

Search this Thread

Feb 11, 2005 | 08:32 AM

rob20rx7

Thread Starter

Injected with a Poison

iTrader: (1)

Joined: Jul 2003

Posts: 795

Likes: 0

From: Miami, FL

Can u use the stock FD Idle Air control valve on the E6K?

I need to know if this can be used, and if so can someone tell me the wires to connect. i have everything already ready to connect. just dont know what wires to hook up.

Feb 11, 2005 | 05:48 PM

crispeed

'Tuna'

Joined: Feb 2001

Posts: 4,637

Likes: 3

From: Miami,Fl,USA

Quote:

Originally Posted by rob20rx7

I need to know if this can be used, and if so can someone tell me the wires to connect. i have everything already ready to connect. just dont know what wires to hook up.

Yes it can be done. Use a PWM to control it.

Feb 12, 2005 | 07:24 AM

rob20rx7

Thread Starter

Injected with a Poison

iTrader: (1)

Joined: Jul 2003

Posts: 795

Likes: 0

From: Miami, FL

would you know which wires it is comming from the haltech, and to which wires do they go on the IAC?

Feb 14, 2005 | 04:40 PM

GUITARJUNKIE28

multipersonality disorder

Joined: Feb 2002

Posts: 5,656

Likes: 0

From: so. cal

use one of the pwm outputs.

you have some grey wires with red stripes in the harness also...use one of those for power.

Feb 16, 2005 | 12:09 PM

pistonsuk

Senior Member

Joined: Oct 2002

Posts: 685

Likes: 1

From: Portland, OR

i'm using an FD BAC w/ E6K. i set ms=14 i think

make sure you "disable" the idle control outputs page for the stepper design and use the BAC under PWM outputs page

justin