I currently have a 13b RE motor that I am building up to run a single turbo in an FB chassis. The question I have here is about a Haltech system on this setup. Can I use a pre-wired 93 Haltech E6K system on this? I do know I will have to re-tune the mapping in it but would most of the connectors and lengths be about right?
Hoping someone a little more experienced can chime in, I have never installed a Haltech before so thats where I stand.

Any info would be great!

thanx

 

You will be real close to a plug n play setup. It all depends on if the coils are in the same location and type. Re-wire fuel pump. and a few others.. Ihave a -rew n my SA.. Running a E6k also

 

Yeah, im pretty sure you can just install it and you will be ok, since the dimensions on the FB chassis are a little smaller than other RX-7s, so no worries there. You will have to fine tune it though.

 

Was told the ignition part of the FD is totally different....in which case I would have to rewire the whole thing as far as the ignition goes. Anyone know?