93 e6k setup work on RE in FB?
I currently have a 13b RE motor that I am building up to run a single turbo in an FB chassis. The question I have here is about a Haltech system on this setup. Can I use a pre-wired 93 Haltech E6K system on this? I do know I will have to re-tune the mapping in it but would most of the connectors and lengths be about right?
Hoping someone a little more experienced can chime in, I have never installed a Haltech before so thats where I stand. Any info would be great! thanx |
You will be real close to a plug n play setup. It all depends on if the coils are in the same location and type. Re-wire fuel pump. and a few others.. Ihave a -rew n my SA.. Running a E6k also
|
Originally Posted by StricklyOldskool
I currently have a 13b RE motor that I am building up to run a single turbo in an FB chassis. The question I have here is about a Haltech system on this setup. Can I use a pre-wired 93 Haltech E6K system on this? I do know I will have to re-tune the mapping in it but would most of the connectors and lengths be about right?
Hoping someone a little more experienced can chime in, I have never installed a Haltech before so thats where I stand. Any info would be great! thanx |
Was told the ignition part of the FD is totally different....in which case I would have to rewire the whole thing as far as the ignition goes. Anyone know?
|
All times are GMT -5. The time now is 07:45 AM. |
© 2024 MH Sub I, LLC dba Internet Brands