RE-SPEED Aluminium Oil Filler Neck Group Buy
#27
Junior Member
Join Date: Apr 2011
Location: North Carolina
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
I just want to apologize in advanced for this (I'm sure) remarkably stupid question but.. what is the fittings and the bung for?? Again, sorry for the newbness, but I also thank you for whoever answers it.
#28
Banned. I got OWNED!!!
iTrader: (2)
It's still 2 pieces, we just change the top piece.
If you would like yours angled a bit more towards the passenger side, we can do that for you. just put that in the notes section when purchasing it, but you have to be specific on the angle, so tell us if you would like it for example "turned 5 degrees more toward passenger side from stock position".
If you would like yours angled a bit more towards the passenger side, we can do that for you. just put that in the notes section when purchasing it, but you have to be specific on the angle, so tell us if you would like it for example "turned 5 degrees more toward passenger side from stock position".
#41
sounds lika Jet
I want to get version 1 non-powdercoated. The problem is I have the Xcessive fd lower intake manifold from pineapple racing so the neck would have to be extended on the midsection from back to front so it can clear the upper intake manifold. since the xcessive lower manifold pushes everything forward a little bit.
pm me please..
pm me please..
#43
Banned. I got OWNED!!!
iTrader: (2)
We had to do some modifications to the jig due to a couple of issues that came up. I would rather send them out fitting right then have them all sent back to be fixed. Sorry for this delay, all of them (minus the last 2 guys that ordered them a couple of days ago), will be going out tomorrow with tracking numbers associated with all of them.
#45
Rotary Freak
iTrader: (24)
here you go:
Please note that mine was extended for about 2/3" outward towards the front of the engine. I am using GZ LIM with stock UIM and Greddy elbow. I have no clue why i needed the extension but this neck was actually made for the use of GZ LIM. It was hitting my throttle little just a tad bit.
Re-Speed was very accommodating and fixed this problem for me with no charge.
Highly recommended.
-AzEKnightz
#47
Senior Member
iTrader: (7)
Join Date: Aug 2009
Location: Bakersfield,Ca
Posts: 412
Likes: 0
Received 0 Likes
on
0 Posts
We had to do some modifications to the jig due to a couple of issues that came up. I would rather send them out fitting right then have them all sent back to be fixed. Sorry for this delay, all of them (minus the last 2 guys that ordered them a couple of days ago), will be going out tomorrow with tracking numbers associated with all of them.
#48
I don't think that I've updated any of the oil filler neck shipping yet for anyone. But most of them already have been shipped out. We only have one left to do and that too should be done today. That one is for a guy in North Carolina with a greddy elbow.
We sold more than anticipated and ran out of flanges for a few order hence why a couple were behind the others.
Last edited by Re-Speed.com; 05-10-11 at 03:53 PM.