would someone like to make a call on this bearing?
Thread Starter
Warming the planet.
Joined: Dec 2004
Posts: 845
Likes: 2
From: Chico, CA
would someone like to make a call on this bearing?
It's just within ideal spec. but it's showing some copper. Your opinion is appreciated.
Last edited by Gadd; Mar 13, 2006 at 10:31 AM.
Joined: Oct 2003
Posts: 11,576
Likes: 27
From: Morristown, TN (east of Knoxville)
You could reuse it if you had to, but I'd replace it if possible. About 10-20% copper showing is the general consensus for reuseable bearing, but you need to have it on the shaft and measure the play to know for sure.
The main bearings on REW's tend to wear a shitload, compared to earlier 13b's where they usually sustain very little wear.
The main bearings on REW's tend to wear a shitload, compared to earlier 13b's where they usually sustain very little wear.
Thread
Thread Starter
Forum
Replies
Last Post