Is there a right way to intall the corner seals ,noticed one side is slightly rough and the other is smooth ,which side goes down in the rotor.

 

Are they new? I would put the smooth side out so that it contacts the side plates, and the rough side in to against the rotor. I never paid close enough attention to the corner seals to notice one side being different.

 

hey, since you had the thread about broken corner seals, I'm guessing these are the new one right? Did you get the ones without the rubber insert?

 

Yes i got new corner seals ,,I did try to get the ones you were speaking about without the rubber inserts and they only come in 3mm.