General Rotary Tech Support Use this forum for tech questions not specific to a certain model year
Sponsored by:
Sponsored by: CARiD

problems

Thread Tools
 
Search this Thread
 
Old Nov 24, 2011 | 12:42 AM
  #1  
EnjoiFC's Avatar
Thread Starter
PistonlessPaul
 
Joined: Oct 2010
Posts: 8
Likes: 0
From: oxnard
Question problems

recently my fc decided to stop turning on, i asked a friend he said check my air flow sensor i messed with it it turned on but after that it wouldnt work, so i changed my sparkplugs and did an oil change too, any other ideas on what the problems coould be and possible solutions?
Reply
Old Nov 24, 2011 | 12:55 AM
  #2  
RawrZac212's Avatar
MEOOOWW-cat back exhaust-
 
Joined: Mar 2011
Posts: 66
Likes: 0
From: Phoenix,AZ
replace the MAF sensor?
Reply
Old Nov 24, 2011 | 02:39 AM
  #3  
ImpartialMouse's Avatar
Full Member
Tenured Member 05 Years
iTrader: (2)
 
Joined: Oct 2010
Posts: 126
Likes: 0
From: Kentucky
Check this out and if the symptoms are the same then it may work for you too =)

https://www.rx7club.com/general-rotary-tech-support-11/blew-my-first-rotary-977738/
Reply
Old Nov 24, 2011 | 09:43 PM
  #4  
satch's Avatar
Moderator
Tenured Member: 20 Years
iTrader: (1)
 
Joined: Jun 2005
Posts: 11,738
Likes: 15
From: tulsa,ok.
What did you do to the AFM? Try jumpering the fuel check connector to start the car.
Reply
Old Nov 25, 2011 | 05:32 PM
  #5  
RotaryEvolution's Avatar
Sharp Claws
Tenured Member 15 Years
iTrader: (30)
 
Joined: Oct 2003
Posts: 5,107
Likes: 50
From: Central Florida
could be a faulty AFM, i ran into one a few weeks ago that would function if you unplugged it and plugged it in a few times with the ignition off+on. i swapped the airflow meter and the issue went away.

the faulty airflow meter was preventing the pump, injectors and ignition from functioning at all, well unless you jumpered the pump test connector but it still wouldn't start.
Reply
Old Dec 20, 2011 | 12:09 AM
  #6  
EnjoiFC's Avatar
Thread Starter
PistonlessPaul
 
Joined: Oct 2010
Posts: 8
Likes: 0
From: oxnard
update replaced the maf today and it started up fine, then it started losing its idle... any suggestions?
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
WyomingTII
2nd Generation Specific (1986-1992)
12
Sep 28, 2015 10:32 AM
lnlreaper
2nd Generation Specific (1986-1992)
2
Sep 27, 2015 09:59 AM
The1Sun
1st Generation Specific (1979-1985)
7
Sep 18, 2015 07:13 PM
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM




All times are GMT -5. The time now is 02:49 AM.