PCV Question
07-26-05, 07:49 PM
#1
Learned alot | Alot to go
Thread Starter
iTrader: (2)
Join Date: Apr 2002
Location: Rotaryland, New Hampshire
Posts: 4,232
Likes: 0
Received 0 Likes
on
0 Posts
PCV Question
I have a 13b-re and my pcv system simply consists of a vacume 't' tying the oil fill and center iron vac nipples together, then running though a check valve which ends up after my TB
Is this ok? Occasionaly my car will make a wirring noise which i was able to track down to this sytem. If the sound starts and i pinch the line at the tb it stops. Doesnt seem damaging to me, however i wanted to ask anyways
Car runs fine, has a few 1000 miles on it sence i started using it. pulls 60-62kpa vac at 900rpm idle
-Jacob
Is this ok? Occasionaly my car will make a wirring noise which i was able to track down to this sytem. If the sound starts and i pinch the line at the tb it stops. Doesnt seem damaging to me, however i wanted to ask anyways
Car runs fine, has a few 1000 miles on it sence i started using it. pulls 60-62kpa vac at 900rpm idle
-Jacob
Last edited by CrackHeadMel; 07-26-05 at 07:51 PM.
07-27-05, 05:16 PM
#2
Banned. I got OWNED!!!
Join Date: Jul 2004
Location: next to the polishing wheel!!!
Posts: 1,179
Likes: 0
Received 1 Like
on
1 Post
I do not run a PCV valve and the nipples are gone . The hole on the throttle body is welded closed and the nipples on the oil fill tube were cut out when I shortened the fill tube .
Thread
Thread Starter
Forum
Replies
Last Post
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM
