nitial run-in on an engine cradle/stand?
Thread Starter
Rotary Freak
Joined: Jul 2001
Posts: 1,817
Likes: 16
From: South Carolina
nitial run-in on an engine cradle/stand?
I have been reading Mahjik's tale of woe in this thread...
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/when-engines-break-pics-411874/page16/
Question...
Since it is a pain to get the engine back into the car, only to find out that something is not right and then have to pull it again, what would it take to be able to do the initial run-in on an engine stand?
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/when-engines-break-pics-411874/page16/
Question...
Since it is a pain to get the engine back into the car, only to find out that something is not right and then have to pull it again, what would it take to be able to do the initial run-in on an engine stand?
Basically, you need an engine dyno setup. Here's an example:
http://videos.streetfire.net/video/5...7d005cb615.htm
I couldn't find a rotary example, but there is one around as I saw a video of a IT racer's engine on an engine dyno.
http://videos.streetfire.net/video/5...7d005cb615.htm
I couldn't find a rotary example, but there is one around as I saw a video of a IT racer's engine on an engine dyno.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
Wicked93gs
Other Engine Conversions - non V-8
0
Aug 23, 2015 10:14 AM
