ok i have been looking for info on this setup every where but there is little to none on it so im trying to reach out to people that have this setup running.

i have a microtech lt8s ecu im trying to run a dynatek ARC-2 ignition to the leadings. but im not having any luck getting them to fire up. were im lost on this is the microtech has a one wire signal for the leading that used the oem ignighter from the stock leading coil to split the signal and fire the leads.
now with the ARC-2 there are 2 signal's in's and 2 signal's out to DC12-1 coils..

what do i need to do to split this signal?

is there anybody who can walk me threw on the wiring of this.

this is the only Manual i have to go with - http://www.schnitzracing.com/manuals/ARC-2.pdf

 

figure ill give this a try again.. if anybody may know what i could do please help i want to go with a PWI setup.

 

you need an x4box or an ignitor to split the signal into 2 otherwise you will loose half the power.

 

or run 2 trailing coils for the leading plugs

 

The microtech is setup for 3x ign outputs. Id change to an LTX that has the 4x ign outputs and purchase an X4 box.

Another option is to purchase a decent ECU.

Im not a fan of splitting 1x ign signal into 2.

 

thanks for responding, i may have to just get on to another ECU, the lt8 is way out of date.. will look around at some other units, would you have any recommendations on a nice affordable ECU..