Need Dimensions
#1
ERTW
Thread Starter
iTrader: (2)
Join Date: Nov 2004
Location: Waterloo, Ontario
Posts: 880
Likes: 0
Received 0 Likes
on
0 Posts
Need Dimensions
Hey guys,
I'm modelling some parts in Catia and I need to know some dimensions, hopefully you know them:
1) Angle of taper on the rear of the eccentric shaft.
2) Flywheel bolt circle diameter (I measured 98mm, I just want to check).
Thanks!
I'm modelling some parts in Catia and I need to know some dimensions, hopefully you know them:
1) Angle of taper on the rear of the eccentric shaft.
2) Flywheel bolt circle diameter (I measured 98mm, I just want to check).
Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM