little big problem :P
Thread Starter
Full Member
Joined: Dec 2003
Posts: 88
Likes: 0
From: N/A
little big problem :P
ok you got under the hood of an 1986 GXL rx-7 a fuse box under the hood you got
an
EGI COMP.30A
EGI INJ. 40A
HEAD. 30A
MAIN. 80A
BLANK ONE NONE IN IT
BTN 60A
and
RETRACTOR. 30A
i always put my BTN fuse in the blank spot because if i put it in where it's suposed to go all my light in my car stays on liek my warning flashs constently my two door lights are on all the time and when i remove it nothing work car start yes but no signal lights or anything an di was just woundering if anyone could help me out with this thx :P
P.S. my brother crashed with it once driver side fender and front bumper got wrecked and the driver side door the pin att the buttom that tell you are door is closed is gone
if anyone coudl help thx again
sorry for my english been learning it for over a year i'm still sloppy thanks
ROTARY POWER FOR LIFE
an
EGI COMP.30A
EGI INJ. 40A
HEAD. 30A
MAIN. 80A
BLANK ONE NONE IN IT
BTN 60A
and
RETRACTOR. 30A
i always put my BTN fuse in the blank spot because if i put it in where it's suposed to go all my light in my car stays on liek my warning flashs constently my two door lights are on all the time and when i remove it nothing work car start yes but no signal lights or anything an di was just woundering if anyone could help me out with this thx :P
P.S. my brother crashed with it once driver side fender and front bumper got wrecked and the driver side door the pin att the buttom that tell you are door is closed is gone
if anyone coudl help thx againsorry for my english been learning it for over a year i'm still sloppy thanks
ROTARY POWER FOR LIFE
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
The1Sun
1st Generation Specific (1979-1985)
7
Sep 18, 2015 07:13 PM
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM
