Fuel Lines?
#1
Wants Traction!
Thread Starter
Join Date: Dec 2005
Location: Regina, SK, Canada
Posts: 292
Likes: 0
Received 0 Likes
on
0 Posts
Fuel Lines?
Im going to put an edelbrock carb on my car and i know it needs to run about 5.5 or 6 psi of fuel. So i bout a carter pump that runs at 7, so im going to regulate it. now pump recommends that i use at least 3/8" line. Stock, on my '79 RX-7 is 5/16" hard line from tank, rubber lines, and hard lines under body. Do i have to up them? Also if i do, how do i increase the one from the tank? as it is a hard line.
#2
Senior Member
iTrader: (2)
I had this problem when I switched to a huge fuel pump and fuel rails. There was just not enough fuel moving from the back to the front.
Its a job and a half but worth it, you can replace the stock lines with larger lines. I did this and now have a ton of fuel on hand for my needs.
Its a job and a half but worth it, you can replace the stock lines with larger lines. I did this and now have a ton of fuel on hand for my needs.
#3
Wants Traction!
Thread Starter
Join Date: Dec 2005
Location: Regina, SK, Canada
Posts: 292
Likes: 0
Received 0 Likes
on
0 Posts
I had this problem when I switched to a huge fuel pump and fuel rails. There was just not enough fuel moving from the back to the front.
Its a job and a half but worth it, you can replace the stock lines with larger lines. I did this and now have a ton of fuel on hand for my needs.
Its a job and a half but worth it, you can replace the stock lines with larger lines. I did this and now have a ton of fuel on hand for my needs.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM