FD crank position sensor ?? (car won't start..HELP !!)
FD crank position sensor ?? (car won't start..HELP !!)
Hi,
Can someone tell me or send me a picture if possible where they are located ??? my FD won't start and I need to check these.
Battery is brand new/I could hear the fuel pump when the key is ON position/and it cranks normally. I suspected a flood so I pulled the EGI->crank->put the EGI back->crank...and still nothing. Plugs are fine too.
Now I checked the LED light on my TEC3 ECU while the key was ON position and the green light stayed on, but when I cranked it, green LED switched to red LED just once and then green LED just stayed on while cranking the motor. I was told (by Ray@PFS)that during cranking, if the CAS/ECU is good, then the LED should blink constantly until engine starts.
Can someone tell me or send me a picture if possible where they are located ??? my FD won't start and I need to check these.
Battery is brand new/I could hear the fuel pump when the key is ON position/and it cranks normally. I suspected a flood so I pulled the EGI->crank->put the EGI back->crank...and still nothing. Plugs are fine too.
Now I checked the LED light on my TEC3 ECU while the key was ON position and the green light stayed on, but when I cranked it, green LED switched to red LED just once and then green LED just stayed on while cranking the motor. I was told (by Ray@PFS)that during cranking, if the CAS/ECU is good, then the LED should blink constantly until engine starts.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
