ERRRR!!!!! ROAR! 3500 rpm turbo cutoff
#1
Full Member
Thread Starter
Join Date: Nov 2005
Location: glendale CA
Posts: 183
Likes: 0
Received 0 Likes
on
0 Posts
ERRRR!!!!! ROAR! 3500 rpm turbo cutoff
Why is it when Im not looking for something its everywhere and when I need it its nowhere to be found??
Where is the write up on the 3500 rpm turbo lag cutoff thing that involves a better ground?
please help
If its on Robinette's site please tell me exactly where,
I HAVE SEARCHED FOR THIS SO DONT TELL ME TO SEARCH, JUST TELL ME WHERE IT IS.
thanks
Where is the write up on the 3500 rpm turbo lag cutoff thing that involves a better ground?
please help
If its on Robinette's site please tell me exactly where,
I HAVE SEARCHED FOR THIS SO DONT TELL ME TO SEARCH, JUST TELL ME WHERE IT IS.
thanks
#4
Lost You in the Rear View
Join Date: Jul 2007
Location: Rocky Hill, CT
Posts: 560
Likes: 0
Received 0 Likes
on
0 Posts
turbo cut?? sounds more like a bad charge door actuator or vac. line, or possibly a bad solinoid. a bad ground only causes hesitation. check your charge door actuator and make sure its still connected. sometimes the clip rusts and breaks off so the actuator rod is just hanging.
the fix with the grounds is just to clean the connections very well. it isn't neccesary to add grounds, but if you do choose to, the best place is to add one to the top of each housing above the spark plugs to the fender. home depot sells little junction blocks that mount right to the fender and look nice and clean.
the fix with the grounds is just to clean the connections very well. it isn't neccesary to add grounds, but if you do choose to, the best place is to add one to the top of each housing above the spark plugs to the fender. home depot sells little junction blocks that mount right to the fender and look nice and clean.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM
rx8volks
Canadian Forum
0
08-11-15 10:30 PM