Engine sitting
#1
Senior Member
Thread Starter
Join Date: Aug 2005
Location: Florida
Posts: 400
Likes: 0
Received 0 Likes
on
0 Posts
Engine sitting
I had purchased a 13b RE Cosmo motor and it looks like it will have to set for awhile, while I gather the parts and funds to complete the project.
The question here is what I should put in the rotor housings while it sits. Should I put normal oil in each chamber or us MMO (Marvel Mystery Oil)? I just dont want my seals to lock up on me.
thanx
The question here is what I should put in the rotor housings while it sits. Should I put normal oil in each chamber or us MMO (Marvel Mystery Oil)? I just dont want my seals to lock up on me.
thanx
#4
Do it right, do it once
iTrader: (30)
I got a tip from a engine builder about 11yrs ago on a seized TII motor w/142k on it. The motor seized from sitting and had not gotten wet but had been exposed to a humid environment. He said dump some Techron fuel injector cleaner down the LIM, pull the plugs and wait a few days. After that I put a breaker bar w/about a 6ft extension on the crank pulley and bolted the front of the engine to my workbench. The motor broke loose.
About 6 yrs later I put it in my TII, it ran for 4yrs until the new owner disconnected the OMP rod... Must have had 180k or better on it.
About 6 yrs later I put it in my TII, it ran for 4yrs until the new owner disconnected the OMP rod... Must have had 180k or better on it.
Thread
Thread Starter
Forum
Replies
Last Post