Differential side bearing preload?
#1
Senior Member
Thread Starter
iTrader: (4)
Join Date: Apr 2004
Location: Charleston, SC
Posts: 340
Likes: 0
Received 0 Likes
on
0 Posts
Differential side bearing preload?
I'm reassembling a 1st gen limited slip diff and I have a question about the differential side bearing preload. The manual says to use a micrometer to measure the bearing carrier 'ear' dimension, when the measurement is between 7.300 and 7.303 inches the preload is correct. Only problem is, no one in my immediate circle of enemies has a 7 to 8 inch micrometer. So, is there a torque spec that can be used for this?
Thread
Thread Starter
Forum
Replies
Last Post