cranking speed sound normal?
Thread Starter
Senior Member
Joined: Aug 2010
Posts: 415
Likes: 8
From: Treasure coast
cranking speed sound normal?
Is the cranking speed you hear on this video normal for a TII?
87 TII compression - YouTube
If I do about 4 or 5 consecutive starting attempts I'll get one faster cranking speed as in this video. When the engine cranks at this faster speed along with no start signal to the ECU's pin 3B, hot start is not an issue and the engine starts almost instantly. The compression at the faster pace is near 95 psi on all rotor faces. At the lower cranking speed compression might see 80-81 psi and hot start is an issue.
The starter is an Autozone rebuilt .
87 TII compression - YouTube
If I do about 4 or 5 consecutive starting attempts I'll get one faster cranking speed as in this video. When the engine cranks at this faster speed along with no start signal to the ECU's pin 3B, hot start is not an issue and the engine starts almost instantly. The compression at the faster pace is near 95 psi on all rotor faces. At the lower cranking speed compression might see 80-81 psi and hot start is an issue.
The starter is an Autozone rebuilt .
Last edited by Clubuser; Mar 27, 2013 at 04:38 PM.
hard to say from a Youtube video.
The Mazda starters are reman as well. It should be better than an autozone one, hopefully, but I'm not sure if you'll notice a difference if the autozone one wasn't dead.
The cranking speed can be affected by battery voltage and oil viscosity. I would think that poor compression would actually turn over faster. Think about how fast the engine turns when it's flooded.
The Mazda starters are reman as well. It should be better than an autozone one, hopefully, but I'm not sure if you'll notice a difference if the autozone one wasn't dead.
The cranking speed can be affected by battery voltage and oil viscosity. I would think that poor compression would actually turn over faster. Think about how fast the engine turns when it's flooded.
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic Cranking fuel table messed up?
sherff
Adaptronic Engine Mgmt - AUS
5
Sep 12, 2015 12:22 PM
83revival
New Member RX-7 Technical
4
Sep 3, 2015 10:42 PM
rx8volks
Canadian Forum
0
Sep 1, 2015 11:02 PM