Cracked front iron
#1
Junior Member
Thread Starter
Join Date: Nov 2016
Location: NC
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Cracked front iron
Hey guys I have a engine with a cracked front iron right at the oil feed banjo fitting driver side front shoots oil out I'm going to strap pieces together and pull front iron does any1 know if and where u can just get a front iron water seal and any insight to this project would be useful
#2
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
You can order any of the seals individually from Mazda.
Mazdatrix has the part numbers on their website.
A cracked front iron if from extreme detonation. Fix that issue. A lot of times caused by triggering problems.
Mazdatrix has the part numbers on their website.
A cracked front iron if from extreme detonation. Fix that issue. A lot of times caused by triggering problems.
#3
Junior Member
Thread Starter
Join Date: Nov 2016
Location: NC
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
think the problem was over tightening the banjo fitting I spent 45 mins with mazdatrix last night lol didn't even think to ask him about the seals
#4
Racing Rotary Since 1983
iTrader: (6)
agree w Aaron. probly detonation.
check tip of f rotor for shiny/contact w rotor housing, also collapsed CS springs.
generally the front dowel pin moves outward cracking the dowel pin well at the oil service port.
often from trigger or crossfire.
H
check tip of f rotor for shiny/contact w rotor housing, also collapsed CS springs.
generally the front dowel pin moves outward cracking the dowel pin well at the oil service port.
often from trigger or crossfire.
H