Cosmo Diagramz Anyone?
#1
Senior Member
Thread Starter
Join Date: Aug 2005
Location: Florida
Posts: 400
Likes: 0
Received 0 Likes
on
0 Posts
Cosmo Diagramz Anyone?
Does anyone have and diagrams for the2 rotor 13b cosmo motor? Such as wiring/vacuum?
Recently purchased a cosmo motor and would like to go through this rats nest of vacuum lines. Although I will be going haltech....but would like to know what I might need to retain in this mess...
Thanx peepz!
Recently purchased a cosmo motor and would like to go through this rats nest of vacuum lines. Although I will be going haltech....but would like to know what I might need to retain in this mess...
Thanx peepz!
#2
registered user
iTrader: (1)
Join Date: Jan 2006
Location: San Diego
Posts: 2,469
Likes: 0
Received 0 Likes
on
0 Posts
use the 13b-rew one in the FD section. Assuming your going non sequential, or using a different turbo, the only lines you retain are the FPR, the one above the primary injector, and the wastegate and BOV. You need to add lines for a the haltech MAP sensor and a boost gauge if you want one. everything else gets capped.
If you want it to be sequental, well good luck.. Actually ask claudio on the haltech forum he has done it with an REW, shouldn't be any different.
If you want it to be sequental, well good luck.. Actually ask claudio on the haltech forum he has done it with an REW, shouldn't be any different.
Thread
Thread Starter
Forum
Replies
Last Post
Sammy Built
Haltech Forum
8
09-28-15 03:18 PM