Carbed 2nd gen.....starting problem?
Carbed 2nd gen.....starting problem?
I have an 89 GXL, which has been carbed and wired to match a 1st gen (the stock electronics were no good).
I have my car wired as prescriped at https://www.rx7club.com/1st-generation-specific-1979-1985-18/can-someone-tell-me-where-these-wires-go-pics-445608/
I went to start it and nothing, found the battery dead, so i charged it for a bit then set to "start". I tried to crank it and there is no starter sound, no cranking, nothing. Just a "zzzzzz" sound i'm guessing because it's on the charger. I have a fuel leak I have to fix before anything else, but what could this be? Is it more than likely the battery? The engine hasn't been cranked in 3-4 months, theres not a chance of it being froze is there?
I have my car wired as prescriped at https://www.rx7club.com/1st-generation-specific-1979-1985-18/can-someone-tell-me-where-these-wires-go-pics-445608/
I went to start it and nothing, found the battery dead, so i charged it for a bit then set to "start". I tried to crank it and there is no starter sound, no cranking, nothing. Just a "zzzzzz" sound i'm guessing because it's on the charger. I have a fuel leak I have to fix before anything else, but what could this be? Is it more than likely the battery? The engine hasn't been cranked in 3-4 months, theres not a chance of it being froze is there?
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM



