can someone answer my questions
Thread Starter
Full Member
Joined: May 2007
Posts: 76
Likes: 0
From: philly
can someone answer my questions
i am rebluiding my 13b n/a i am plaining on doing a basic rebluid i was wondering if if any one new the specs on apex seals i would like to reuse them the engine didnt blow it just had low compression so i desided to rebliud before it blew
Lives on the Forum
Joined: Feb 2001
Posts: 26,664
Likes: 22
From: n
Some suggestions...
First, use a more descriptive title instead of just "can someone answer my questions".
Second, you might want to try the proper generation subsection, since there is a lot more participation in those sections - you did mention you have a 2nd gen here.
Third, the answer is in the FSM.
New - 8.0mm
Replace inner apex seal spring - 7.5mm (don't ask me why)
Wear limit / replace - 7.0mm
-Ted
First, use a more descriptive title instead of just "can someone answer my questions".
Second, you might want to try the proper generation subsection, since there is a lot more participation in those sections - you did mention you have a 2nd gen here.
Third, the answer is in the FSM.
New - 8.0mm
Replace inner apex seal spring - 7.5mm (don't ask me why)
Wear limit / replace - 7.0mm
-Ted
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic S5 Turbo PNP Unit questions
_Tones_
Adaptronic Engine Mgmt - AUS
10
May 25, 2021 05:37 AM
Nosferatu
2nd Generation Specific (1986-1992)
7
Sep 5, 2015 02:13 PM