I just bought a 87 rx7 13B(convertted to a carb'ed car). I stripped the motor, tranny, and wire harness (n326 ECU) . The drive train is going in to a 86 B2000 I would like to keep the N326 to run the dizzy and only the dizzy. I followed the wires and wrote where I pulled every thing off , but lost the paper . I am looking for any one that would have the wire diagram, so I can make this happien. I have talked to many people and they told me just to snag a dizzy off the 81-83 and the coils, but every one is doing that and I would like my mod to be just a little differnt then every one else . Any pointing in the right direction would be nice . I dont mind RTFM from time to time just haven't found the right one



thanks ,
ryan

 

also the body is up for grabs

i stripped it down ...so any one looking for the "race car project" this is for you

and i mean stripped no harness at all just a rolling shell and all the glass

 

was this the wrong spot to post in?

 

I cannot help. there is a local guy (atkinsdan on the forum) who built a 13b super'd b2200 truck. Call up his shop and ask him what he would think.
heres a pic

 

yeah I have talked to dan and tracked down kenny from the old mazdas & more
and a few others with no luck