After 5.5RPM Full Throttle Bogs Down
#1
Junior Member
Thread Starter
Join Date: Nov 2006
Location: Ft Wayne, IN
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
After 5.5RPM Full Throttle Bogs Down
'84 Non-Turb 5 Speed
Question
When I am in N or any other gear if I floor it after it passes 5500RPM it will bog down and jerk real bad until I let off. I can get it up to 7500RPM as long as I don't floor it and play with the throttle. I thought i might have been something with the mixure so I played with it a bit. I got 3 1/2 turns to the lean (I think couter clockwise is leaning, correct me if I am wrong) and it does get better, but I just want to see if it might be something else.
Other than that the car runs fine now that I have cleaned up the carb, replaced basic parts (fuel filter, air filter, changed oil (was coming out in chunks), sparkplugs.
Thanks for the help!!
Question
When I am in N or any other gear if I floor it after it passes 5500RPM it will bog down and jerk real bad until I let off. I can get it up to 7500RPM as long as I don't floor it and play with the throttle. I thought i might have been something with the mixure so I played with it a bit. I got 3 1/2 turns to the lean (I think couter clockwise is leaning, correct me if I am wrong) and it does get better, but I just want to see if it might be something else.
Other than that the car runs fine now that I have cleaned up the carb, replaced basic parts (fuel filter, air filter, changed oil (was coming out in chunks), sparkplugs.
Thanks for the help!!
#3
Junior Member
Thread Starter
Join Date: Nov 2006
Location: Ft Wayne, IN
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
What came with the car I assume. I bought it about a month ago so I'm not sure what the other guy has done to it. In the condition I got it in I don't think it changed or replaced anything.
#5
Junior Member
Thread Starter
Join Date: Nov 2006
Location: Ft Wayne, IN
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
The carb is stock too, i'll take a look at the fuel pump and replace it if needed and see what that is.
When I changed the oil it came out almost like sour milk, but before hand when I checked the dip stick it looked fine. I took of the oil pan and scrapped off good half inch of sour oil if you could call it that and flushed the system with clean oil. I checked all the seals and what not and everything looked fine. It might have been that the oil pan was never cleaned, if the guy before be changed his own oil I don't know.
After I did that tough the car ran a lot smoother and did sound better :-)
When I changed the oil it came out almost like sour milk, but before hand when I checked the dip stick it looked fine. I took of the oil pan and scrapped off good half inch of sour oil if you could call it that and flushed the system with clean oil. I checked all the seals and what not and everything looked fine. It might have been that the oil pan was never cleaned, if the guy before be changed his own oil I don't know.
After I did that tough the car ran a lot smoother and did sound better :-)
Trending Topics
#8
Moderator
iTrader: (3)
for the oil-thing (sour milk, creamy whitish???) sounds like the case was not being vented adequately. either that or water/antifreeze is getting into your oil. one's not so bad, the other may mean a rebuild is on your horizon.
on the other issue, you've got me stumped on one detail. you need to identify what carbie you've got, because there was no stock 13B carb in 1984. if you have an SE they came fuel injected. the only way a carbie is on it, is if someone put it there. can you post some pics of your setup?
on the other issue, you've got me stumped on one detail. you need to identify what carbie you've got, because there was no stock 13B carb in 1984. if you have an SE they came fuel injected. the only way a carbie is on it, is if someone put it there. can you post some pics of your setup?
#9
Junior Member
Thread Starter
Join Date: Nov 2006
Location: Ft Wayne, IN
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
HAHA OK I screwed up one detail - its an 82 not 84 my bad (eek). The oil isn't coming out white LOL i was using the sour milk as a discription of its consistancy, not color.
#13
Junior Member
Thread Starter
Join Date: Nov 2006
Location: Ft Wayne, IN
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
i replaced the distriputer rotor and cap, but havn't made any adjustments to timing or anything.
I'll give the fuel pump a try and let you know what comes of it.
thanks again for all the help
chris
I'll give the fuel pump a try and let you know what comes of it.
thanks again for all the help
chris
#14
Junior Member
Thread Starter
Join Date: Nov 2006
Location: Ft Wayne, IN
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
Figured out why it was bogging out. The guy I guess who had it before me broke the choke cable and screwed with the tuning (mixture and throttle) so it would start. I realized that after I had it tuned up and no longer bogging down. When I went to start it in the morning it would start. I put the mixture back and it cranked right up.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM