1990 626 valve cover gasket
#1
1990 626 valve cover gasket
Sorry this isn't about rx7's but I have a question. I was changing my valve cover gasket on my daily driver and was tightening one of the bolts to the valve cover and it broke off. It's the rear left one. Is it bad if I drive without it? Will it still leak? Or will the other bolts keep it from leaking? Thanks.
#2
Full Member
Join Date: Nov 2001
Location: Springfield, MO
Posts: 206
Likes: 0
Received 0 Likes
on
0 Posts
It should work just fine; if it leaks, then replace the bolt.
Actually, if I were you, I'd take the valve cover off and remove the broken bolt so you can replace it anyways. Typically, it involves a pair of channel-locks or vice-grips. Worst-case scenario requires a small drill-bit and an "EZ-out" bolt extractor. All these tools are readily available at any automotive store.
Actually, if I were you, I'd take the valve cover off and remove the broken bolt so you can replace it anyways. Typically, it involves a pair of channel-locks or vice-grips. Worst-case scenario requires a small drill-bit and an "EZ-out" bolt extractor. All these tools are readily available at any automotive store.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
08-09-18 05:54 PM