13B First Build Need some Advice
Thread Starter
Joined: Aug 2002
Posts: 1,482
Likes: 3
From: St. Paul, MN
13B First Build Need some Advice
Hello,
I am about to rip into my FD's blown engine. I was wondering if there are any tips or things that I need to really watch for when reassembiling these engines? Also were would I send my irons to be cut? I want to do a good job and make sure every thing is right. I am reusing my old housings. Would It be wise to use stock mazda seal?
Thanks
Chris
I am about to rip into my FD's blown engine. I was wondering if there are any tips or things that I need to really watch for when reassembiling these engines? Also were would I send my irons to be cut? I want to do a good job and make sure every thing is right. I am reusing my old housings. Would It be wise to use stock mazda seal?
Thanks
Chris
Thread
Thread Starter
Forum
Replies
Last Post
datfast1
Old School and Other Rotary
18
Jun 20, 2019 10:53 PM
datfast1
West RX-7 Forum
3
Sep 14, 2015 06:58 PM
risingsunroof82
1st Generation Specific (1979-1985)
8
Sep 7, 2015 01:11 PM