RX7Club.com - Mazda RX7 Forum
fully closed throttle plates
fully closed throttle plates
0 2025/01/23 16:46:16
Initial fitting
Initial fitting
0 2025/01/23 16:46:14
Initial attachment
Initial attachment
0 2025/01/23 16:46:13
5mm hex bolt
5mm hex bolt
0 2025/01/23 16:46:11
Adjusted arm angle
Adjusted arm angle
0 2025/01/23 16:46:09
air horn clearance
air horn clearance
0 2025/01/23 16:46:07
Tapping the stock bracket
Tapping the stock bracket
0 2025/01/23 16:46:05
Spring height
Spring height
0 2025/01/21 15:32:08
Interior parts
Interior parts
0 2025/01/21 15:32:06
membrane
membrane
0 2025/01/21 15:32:04
Failure area
Failure area
0 2025/01/21 15:32:02
0 2025/01/16 13:16:26
0 2025/01/15 16:53:29
Rotor bearing failure at 30 mph
Rotor bearing failure at 30 mph
0 2025/01/14 20:59:47
reusing the new egr pin
reusing the new egr pin
0 2025/01/14 17:07:07
0 2025/01/03 20:01:46
0 2025/01/03 20:01:43
0 2025/01/03 20:01:38
0 2025/01/03 20:01:32
0 2025/01/03 20:01:26
0 2025/01/03 20:01:20
0 2025/01/03 20:01:15
0 2025/01/03 20:00:12
0 2025/01/03 20:00:10
witness marks from fully closing the throttle valve while the coating is still wet
witness marks from fully closing the throttle valve while the coating is still wet
0 2024/12/30 18:30:25
leather block to hold open the throttle valves
leather block to hold open the throttle valves
0 2024/12/30 18:30:21
Pencil to move the fast idle cam and have the throttle plates fully closed
Pencil to move the fast idle cam and have the throttle plates fully closed
0 2024/12/30 18:30:17
polished thermowax
polished thermowax
0 2024/12/26 19:49:04
Proper way to test the diaphragm
Proper way to test the diaphragm
0 2024/12/23 16:23:57
0 2024/12/22 18:50:52
0 2024/12/22 18:50:50
0 2024/12/22 18:50:47
five parts of the bracket assembly
five parts of the bracket assembly
0 2024/12/18 20:03:27
assembled parts
assembled parts
0 2024/12/18 20:03:21
This is Rexy, all dressed up & nowhere to go!
This is Rexy, all dressed up & nowhere to go!
0 2024/11/30 07:51:06
using spring clamps on a vacuum line
using spring clamps on a vacuum line
0 2024/11/29 16:32:59
TPS installed and adjusted to 1k ohms
TPS installed and adjusted to 1k ohms
0 2024/11/28 21:18:24
0 2024/11/28 21:14:56
wear point on cam
wear point on cam
0 2024/11/23 21:56:17
0 2024/11/23 21:56:14