FD Drilled Aluminum Brake pedal for Auto trans
Thread Starter
Joined: Feb 2001
Posts: 1,107
Likes: 3
From: Federal Way, WA
FD Drilled Aluminum Brake pedal for Auto trans
I finally got off my *** & manufactured a drilled/dimpled aluminum brake pedal for all you Auto FD owners.
It's based on my drilled/dimpled aluminum dead pedal design.
Easy to install, no drilling required. Just remove the rubber cover & screw the aluminum cover over the stock pedal.
IM going to offer the 3 piece set (dead, gas & brake) for $100. Check out the post in the 3rd Gen "Parts for Sale" section for ordering info.
THX,
It's based on my drilled/dimpled aluminum dead pedal design.
Easy to install, no drilling required. Just remove the rubber cover & screw the aluminum cover over the stock pedal.
IM going to offer the 3 piece set (dead, gas & brake) for $100. Check out the post in the 3rd Gen "Parts for Sale" section for ordering info.
THX,
Thread Starter
Joined: Feb 2001
Posts: 1,107
Likes: 3
From: Federal Way, WA
Thread Starter
Joined: Feb 2001
Posts: 1,107
Likes: 3
From: Federal Way, WA
Ok, lets try this hperlink thing againhttps://www.rx7club.com/forum/showth...threadid=91038
Thread
Thread Starter
Forum
Replies
Last Post
CaptainKRM
2nd Generation Specific (1986-1992)
14
Aug 26, 2015 09:52 PM
fastsaab
New Member RX-7 Technical
5
Aug 19, 2015 11:42 AM
