93redFD

does anybody use a haltech with there stock twins??

rxrotary2_7

do you mean sequential or non-seq.? it can be done both ways from what i have read. seq is just a bit more involved. check out the "silverbulletrx7" site. i forget the addy, but look around on here you will find it.

Styk33

Most people seem to have the stock twins on with an E6K for some time. I have wiring for how to wire it up using the stock harness for sequential and non-seq. Sequential involves hooking up an extra relay and 5 more wires, no big deal.

K2RD.com has a wiring harness that will allow you to keep your stock harness intact if you like. Easy to install and works great.

I have maps on my site and if you have something better let me know and I will put it up there for others.

Have a nice day.

rxrotary2_7

thats what i meant. ricemobile not silverbullet. sorry, 14hrs days at work make me NUTS

jbtam99

Jay,
great info on your site there, any clue on the smog pump though? Houston is getting as bad as Cali for emissions with the new dyno testing, and I don't want to go with a midpipe quite yet.

oh, I did make a shortened version of your seq turbo instructions for my tuner. Hope you don't mind, but if anyone wants me to pass it on, let me know.

John M.
'93 Base VR

rxrotary2_7

pm it to me.

Styk33

I would put up the shortened directions on my site. I seem to have to explain them a lot to people. Just do not have a ton of time to redo the Haltech write-up.

Did I PM you about the airpump wiring already? Someone asked me last week.

IrishCarBomb

Sorry to bring this back from the dead, but does anyone have this write up they are talking about?

All of my searching leads me to hitman, k2rd, and ricemobile.net. I still can't find a how-to (or at least wiring diagram) for installing a haltech with the stock twins at any of these sites. I would prefer sequential, but I could use a non-sequential diagram as well.

If anyone could help me out, I would really appreciate it.

Thanks.

Greg

Silver7

you should be able to find it here:
http://www.scuderiaciriani.com/rx7/haltech_install.html

IrishCarBomb

I did see that figure, but I was under the impression that was for a non-sequential set up. I think I can figure out the non-sequential configuration, but it would be nice to have something that is proven to work just in case.

Thanks for your help though.

Greg

Silver7

the diagram on that page is for sequential operation. only the wastegate solenoid is used during nonsequential operation. The rest are eliminated.