mandrel-bends.com

Has anyone bought anything from this company? They're prices seem pretty good. Does anyone know of a cheaper place? I'm looking to buy materials to fabricate a turbo manifold and I need about 6' of 2.75" 0.065" wall 6061 aluminum.

 

I bought from them numerous times, both stainless steel and aluminum. Good deal...probably the best deal out there on the common stuff. The drawback is that their selection is a little limited.

Chris

 

Thanks Chris. I noticed the limited selection too when I was trying to find 321 SS. I've never welded 316 SS but I think I'm going to give it a try. Burns SS is so overpriced.

 

never heard of this site. i gotta check them out

 

http://www.globaltecheng.com/elbows.asp

 

http://www.mandrelbendingsolutions.c...let/StoreFront

I never bought anything form them, but they seem to have decent prices. Also located in MD.
They have a ebay store also http://stores.shop.ebay.com/Mandrel-...__W0QQ_armrsZ1


EDIT: I didnt see any ss321, but they have 304 and 409

 

They are 30mins from me but I called and they do not carry 2.75" 6061 aluminum tube. They only have 2.5" and 3" in stock.

 

bought from them before, nice people to deal with

 

My bad, I missed the part were you asked for 2.75

 

It's all good. I was thinking of going with 2.5" intercooler tubes for better throttle response and low end. 6' of 2.5" should be plenty and it's $36 from that place and the place is 30mins from me...but then i'd have to buy new silicone couplers and t-bolt clamps...might be worth it.

 

i gotta check em out