Engine Management Forum Use this area for discussing Haltech, Wolf 3D, Power FC, AEM and any other aftermarket ECU upgrades. Help/Questions/Tuning

wire harness fire

Thread Tools
 
Search this Thread
 
Old Jul 13, 2004 | 01:34 PM
  #1  
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Jan 2003
Posts: 124
Likes: 0
From: kamloops b.c
wire harness fire

i was out driving today and i smelt somthing burning. i poped my hood and the wiring harness was on fire so i blew it out and looked at the damage. Im pretty sure the ACV shorted out cause the wire to the top conector was burned right out. and all the conectors by the altanator are all melted. the car still runs fine for now and isnt shorting out anymore. the acv is now unpluged from the harness, but i dont know if i should even start it with the acv not hooked up. its going to be dam near imposible to get a new harness for a lil while so i might just try to rebuild the wires the best i can.


so i just want to know if its ok to just leave the acv in non working mode for a while. and what will a new harness run me??
Reply
Old Jul 14, 2004 | 12:09 AM
  #2  
RETed's Avatar
Lives on the Forum
Tenured Member 10 Years
 
Joined: Feb 2001
Posts: 26,664
Likes: 22
From: n
1988 GXL?
Emissions won't work properly, but it shouldn't hurt anything temporarily.


-Ted
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
gxl90rx7
Haltech Forum
4
Sep 14, 2015 03:09 PM




All times are GMT -5. The time now is 08:30 PM.