Hi all I am posting this with hopes to get some useful info.

Prior to putting the new engine in I need some info and advice.

So far I have...
#1- The car with the stock engine in it that I can not get to run.

#2- A new stage 3 ported and polished engine.

#3- A full 3 inch downpipe with 2 welded bung holes one for a stock 02 sensor and one for a wideband 02 sensor, Stock cat for emmisions, and a 80mm Cork Sport Full Turbo Back Exhaust & Apexi Exhaust Control Valve.

Now before I have the engine put in I want to get a few things to make sure it will run properly and I want to do it the right way from the start. I know once I put in the new engine and put on my new exhaust the stock ecu will not be able to supply enough fuel for the amount of boost I will hit due to changing the exhuast and air filter. The most important thing for me to decide on is which stand alone ecu would be best for my car and me! I would hope to get one that I can learn to tune myself. Originally I was looking at the Microtech lt10s, I was adviced by a friend that he has the Wolf3D V4 Plus and that I might want to consider getting that ecu(Wolf3D V4 Plus ) for my car becuase he learned to tune it and i might be able to too.


Which stand alone ecu would be best for my car and easy for me to learn to tune myself?? Is the Wolf3D V4 Plus a good ecu?

I was looking to buy some secondary injectors to replace the stock ones(1987 turbo2) should i go for 720cc or bigger? Also is there a certian impedence or spray...Anything I should know when ordering injectors?



Thanks all...

 

Thanks for the help... Guys I thought someone would have some useful info or advice.

 

Quite a few people took time out of their personal life in order to help you.

https://www.rx7club.com/showthread.p...6&page=1&pp=15