RX7Club.com - Mazda RX7 Forum

Engine Management Forum Use this area for discussing Haltech, Wolf 3D, Power FC, AEM and any other aftermarket ECU upgrades. Help/Questions/Tuning

ne 1 have tips on removing the stock ECU

Thread Tools
 
Search this Thread
 
Old 06-03-02, 01:24 PM
  #1  
Full Member

Thread Starter
 
s4play's Avatar
 
Join Date: Apr 2002
Location: new york
Posts: 174
Likes: 0
Received 0 Likes on 0 Posts
Unhappy ne 1 have tips on removing the stock ECU
I do not have a short enough screw driver!!!!
s4play is offline  
Reply Like
Old 06-03-02, 02:52 PM
  #2  
Full Member

 
grampa's Avatar
 
Join Date: Jul 2001
Location: MA
Posts: 242
Likes: 0
Received 0 Likes on 0 Posts
Have you tried just undoing the nuts holding the brackets to the car first?
grampa is offline  
Reply Like
Old 06-03-02, 03:09 PM
  #3  
Full Member

Thread Starter
 
s4play's Avatar
 
Join Date: Apr 2002
Location: new york
Posts: 174
Likes: 0
Received 0 Likes on 0 Posts
Thanks, nope the ones on the bottom? worst comes to worst I'll just dremel the tops of the screws off, won't need them any more!
s4play is offline  
Reply Like
Old 06-04-02, 09:26 AM
  #4  
Full Member

 
grampa's Avatar
 
Join Date: Jul 2001
Location: MA
Posts: 242
Likes: 0
Received 0 Likes on 0 Posts
If you dremel be careful of getting metal dust in the ECU.
Not good for electronics.
grampa is offline  
Reply Like
Old 06-25-02, 01:37 PM
  #5  
Banned. I got OWNED!!!
 
Badog's Avatar
 
Join Date: Mar 2001
Location: Bannished
Posts: 1,008
Likes: 0
Received 0 Likes on 0 Posts
Use a right-angle screwdriver. Sears sells them.
Badog is offline  
Reply Like
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Installed UIM gasket, now my engine won't run
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Back to Subforum
Engine Management Forum
View Next Unread
need some help




Advanced Search
Quick Reply: ne 1 have tips on removing the stock ECU


Reply Closed Thread Share

All times are GMT -5. The time now is 08:13 PM.