Mercury Marine Coil - CAD Layout
#1
Senior Member
Thread Starter
Join Date: Aug 2001
Location: Santa Barbara, CA
Posts: 271
Likes: 0
Received 0 Likes
on
0 Posts
Mercury Marine Coil - CAD Layout
In case anyone else is needs it, I went through and made up a DXF of my Mercury Marine coils (339-832757A 5). It's accurate/precise enough to make mounting plates/brackets from it. I made this after wasting time freehanding a mounting plate, and having it look awful.
The DXF of the above is attached (built with QCAD).
The DXF of the above is attached (built with QCAD).
Thread
Thread Starter
Forum
Replies
Last Post
rotor_veux
2nd Generation Specific (1986-1992)
3
09-28-15 09:25 PM
killerrx710
Adaptronic Engine Mgmt - AUS
5
09-28-15 09:13 AM
killerrx710
2nd Generation Specific (1986-1992)
1
09-24-15 10:57 PM