Haltech and stock wastegate solenoids
06-09-01, 12:52 AM
#1
Full Member
Thread Starter
Join Date: Mar 2001
Location: las vegas
Posts: 183
Likes: 0
Received 0 Likes
on
0 Posts
Haltech and stock wastegate solenoids
i am using e6k for a cosmo 2 rotor. can i use both stock wastegate solenoids. i have a blitz dual sbc. but i don't understand how it works in sequential. if i have it setup for 10psi will the first turbo get there before the second? wouldn't both wastegates open at the same time? if the later occured will then the second turbo ever reach 10psi?
06-13-01, 11:31 AM
#2
Queer
Join Date: Mar 2001
Location: Formerly in the Ass end of the pacific.
Posts: 742
Likes: 0
Received 0 Likes
on
0 Posts
Hey dude. Dunno about the EBC because I have never had one for a sequential setup but I would think it would have to have 2 solenoids to run each actuator. How many does yours have? Do you have the instructions?
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM