Blitz SBC icolor
Thread Starter
Junior Member
Joined: Mar 2008
Posts: 40
Likes: 0
From: AC, Germany
need help... boost controller installation 
i installed it correctly but no funktion! no gauge ... allways "0" damn ****
done like this:
1) Find somewhere dry to mount the solenoid valve, and also mount it so that the NC (Normally Closed) outlet faces down or to the side, as this will
bleed off air from the wastegate.
2) Remove the caps from ALL of the ports, and then attach the two pipe barbs to the COM and NO (Normally Open) ports.
3) Remove the original tubing on the front of the Turbo - there is a T piece in it which goes off to the stock boost solenoid - you need to cap this off -
it's not needed.
4) Run a hose from the COM port to the Wastegate actuator - as you look at the turbo from the front, this is underneath and to the left of the turbo.
5) Run a hose from the NO port to the little outlet on the neck of the Turbo compressor - this will be close to the pipe coming vertically off the turbo.
6) Feed the wiring loom for the solenoid valve through the bulkhead and into the drivers footwell.
7) Locate the vacuum pipe that feeds either your Blow off valve or recirc valve, and insert the T piece suppliied with the kit. Run a hose from the free
end of this to the small filter (also supplied with the kit) and then another hose through the bulkhead and into the back of the controller.
8) Connect up a 12 supply and the control cable for the solenoid and your ready to go !
....
i installed it correctly but no funktion! no gauge ... allways "0" damn ****
done like this:
1) Find somewhere dry to mount the solenoid valve, and also mount it so that the NC (Normally Closed) outlet faces down or to the side, as this will
bleed off air from the wastegate.
2) Remove the caps from ALL of the ports, and then attach the two pipe barbs to the COM and NO (Normally Open) ports.
3) Remove the original tubing on the front of the Turbo - there is a T piece in it which goes off to the stock boost solenoid - you need to cap this off -
it's not needed.
4) Run a hose from the COM port to the Wastegate actuator - as you look at the turbo from the front, this is underneath and to the left of the turbo.
5) Run a hose from the NO port to the little outlet on the neck of the Turbo compressor - this will be close to the pipe coming vertically off the turbo.
6) Feed the wiring loom for the solenoid valve through the bulkhead and into the drivers footwell.
7) Locate the vacuum pipe that feeds either your Blow off valve or recirc valve, and insert the T piece suppliied with the kit. Run a hose from the free
end of this to the small filter (also supplied with the kit) and then another hose through the bulkhead and into the back of the controller.
8) Connect up a 12 supply and the control cable for the solenoid and your ready to go !
....
