Hi Guys and Girls

Those off you that are running aftermarket ecu`s for fuel only purposes.....

Where did you connect the wire going to the ecu to fire the injectors ?

Is it to the + or the - side of the coil ?

Thanks!

Karis

 

heloooo??
Doesnt anybody ever come to this section ?

 

You should not hook up anything until you check with your EMS manual.

If you are asking which wires of an EMS normally hook up to the fuel injectors, there is usually one 12VDC common lead that is operated by the EMS via a relay, and there are usually several ground leads marked something like INJ1, INJ2, etc., which hook up to individual or banks of fuel injectors.

The more advanced sections like this do not have as much traffic as the other sections of this forum. If you are going to have a panic attack after waiting only 2 hours for a response, then you should maybe see a doctor about your condition.

 

Ahhh! thanks for replying!

Well,i`ll have alook at it !I`am just not sure,if the ignition trigger going into the ECU goes before,or after the ignition amplifier,wen using it for fuel only.

Panick attck ? Me...? Never1I`am just used to quick,answers!

hahaha!

Thanks Again!

Karis!