whos going? Im trying to finish my gold rx7 to compete on the 28th!!!!

theres huge payouts!

 

I'm registered for the after comp drifting. I don't have the cash for a full cage and seat yet.

Now I gotta figure out why the damn FC decided to not start last night.

 

i heard you just need a roll bar and door bars right? It doesnt have to be the full FD legal cage.
and FIA seat and harness...

I hope this is the casee, i dont have a fd legal cage yet

 

I just bought a DD Lexus sooo im prolly not gonna make it


DK come down here so we can tandem all close and ****!!!!

 

Here are the rules
http://www.allstarcarbattle.com/form...quirements.pdf

 

sean might make it if he gets the cage put in... hes got like 66ft of chromoly just sittin at the crib.

wonder if the fuel cell needs a firewall and ****, if so he would have to pull that out, sell it, then have a surge tank made and install that and the gas tank.

or box the cell in.

i need too much ****. idk if my bride seat is a knock off, cuz no sticker. a suit, helmet,and cage is at least a thousand bucks.


ive driven west track though, ***** fun!!! only 2nd gear too, the straight away is 3rd but i dont think thats in the judged turns.



Is there a map with the Start/Finish line?

 

I think I read surge tanks need a firewall. Not sure about fuel cells

I do 3rd on the first section and then downshift to 2nd at the tight right turn before the U.
I wish they were starting further back.
I start at that first turn and do a quick manji into the tight right.

here's a crappy vid of the course.

 

the straight away is way fun!!!! i was in 3rd doing ebrake longslides off that **** when i was NA...

 

Sonic motor will be there !

 

doood im super excited about this event!!!

so down to tandem!

Im rebuilding my engine next week with new apex seals and wiring up the E8 haltech.
Next paycheck goes to a Pro2000 seat and harness.. fuuu alot of $$$$

cant wait to drive my gold fc againn

all my money from pepboys is going to this trip!!!

 

im going to try to go but all my cash is going to FD vegas...if the car is intact and i dont get dropped maybe i can get out there for this!!!!!!!!!

more FC madness!

 

This weekend im going to upload my map back onto my haltech... if it runs fine then im going to start on the cage.


if the fc runs like **** after i load the map, then the haltech is prolly fucked.


Sucks my bride seat has no FIA sticker on it... i heard that the JDM ones dont have it????

if i dont make it, then im going to help my bro get out there...

A local will when this!!!!

 

lol at XDC no one even looked at my seat sticker or cage.... they failed me on tech for my 5th harness not being in the car.... so you should be alright.

they litterally were like:

"cage - check, approved seat - check, harness bolted correctly - check, 5point strap.....where the **** is your 5th point"

lol. its a bride. hell even if its a knock off its still made in the same building lol. you should be cherry. goodluck with the haltech **** though.

 

And this muh fukah is signed up...
Cant wait to see every one out there...
Good luck!!

 

whaaaaatttt?? is it that easy???? here I am tripping out about my car passing tech..

My car is almost running, haltech is 90% wired up.. My fresh rebuild compression tested at 113psi front and 118psi rear with brand new RA apex seals springs and RA oring kit.. The engine should run reaall gooddd.
running 1000cc secondaries.. 680 primary.. going to get a tune in2 weeks..

its gunna be sweeeeeeettt..

Real excited..

Just ordered a sfi harness ,and driving suit.. I still need the shoes tho..

Did they check your shoes and gloves if they were sfi??

fuuuuuu all my money is going to this..... im putting extensions on all my tickets..

 

Message George or Joe if you're worried about rule book issues. They'll probably be fine with what you have.

 

dudes

i might be competing

 

sweeeett we need more rotary out there ! Wheres the colorado guys at??

 

finally got the laptop and hooked it up to the fc...


the haltech is fine and the timing is dead on.

maybe the car is running like **** because the motor is blown? soon as i get off work im checking the compression...

 

are you running the haltech water temp and tps and air temp sensors??

i heard you can run stock water sensors and s5 tps,and 3 bar map is this true?

 

^^You can run whatever you want, but as far as I know, you need the haltech sensors to make it work correctly.

 

stressed.. car isnt running yet, 2 days left to get it running

 

It's slightly rainy today.

The temps should be really nice.
There's word of afternoon/night rain tomorrow but we'll see if it hits that part of the valley. I'm over in the area now and it's all to the west of here.

A word of warning. If a storm does come through. Make sure a rim or two are holding your tent down. We get crazy wind gusts right before the rain.

 

im running stock water temp sensor... works perfectly fine. i have a gm one too

i have a s5 engine and mani's now but i modded my s4 throttle body and just used that. i dont think the s5 tps fits on the s4 tb.

using a 3 bar gm map too. stock air temp sensor. i also have a gm one of these







sooooo my bro is getting the cage together right now, got the main hoop and the a pillars or whatever. got the belt and i ordered the suit for him.

waiting on the a1000 to come back from jegs... **** somehow stopped working. but hes borrowing a $700 fuel pump just in case the a1000 doesnt show up in time

 

fuuuucccc my harness isnt wired up right, a friends redoing it right now. Havent left california yet , so last second..

anyone have schematics for a E8 haltech to stock t2 coils??