Ok So I am just about ready to paint the inside of my car, (I have removed the dash and all interior and have the car fully stripped).

What is a good primer and paint to go with? and what kind of seam sealer should I use?

Im planning to paint it seafoam green and want it to look good as its my first actual paint job. Im shooting the paint out of a matercraft paint gun. I was planning to do 3 coats primer with light sanding between coats and 3 coats paint. If anyone has any suggestions or tips that would be awesome im doing as much research as I can.

Thanks

 

Its gonna be hard to sand the interior.... But red pads will scuff it good

 

interior is all sanded down already and taped, my paint room is up I just have to figure out what materials to use.

Any help is appreciated

 

Can anyone with experience in doing this go through the process?

What is the best primer/paint/seam-sealer to use? How many coats of each?

 

Man I just went over mine with a wire wheel to get any left over sound deadning off, then rubbed it down with wd 40, then cleaned it all with soapy water. Sprayed it with black spray paint and it came out awesome. I'm sure anything out of a gun would come out fantastic. Unless you sanded it down to metal do you even need primer? The rattle can stuck great to the factory paint.