Hey there

I swapped a manual engine and transmission into an automatic car. Thought it would be fairly straight forward, and it was mechanically. As for the wiring, this one conector doesn't match up between the auto body and manual engine harness.




Does anyone have RHD wiring diagrams? Just need to know how to repin the connector to make this work.

Found instructions on here for a LHD FD but the wire colors don't seem to match the RHD FD (big surprise).

Last resort will be swap the whole front body harness which will be a lot more work than just a simple repin.

Thanks for any help!

 

Try looking at a Auto car's wiring,and then what a Manual setup has..
I think that is where you are going wrong.

 

I have a manual pigtail and still don't have the proper colors. The LHD wiring seems different than RHD

 

Just compare it to a LHD, the pins are still going to be the same even if the colors are different.

thewird

 

That's what I was thinking, but didn't want to start repinning without being sure.