Where to buy Pure Methanol?
Thread Starter
Joined: Oct 2006
Posts: 6,603
Likes: 15
From: Toronto, Canada
Right now the cheapest source getting a barrel from VP Racing Fuels...
54 Gal (204 liter) Drum of M1 - $300 (tax included) + $25 refundable drum deposit
$1.47 /liter
I still have to get in contact with Ashland... I think that is going to be the cheapest source.
thewird
54 Gal (204 liter) Drum of M1 - $300 (tax included) + $25 refundable drum deposit
$1.47 /liter
I still have to get in contact with Ashland... I think that is going to be the cheapest source.
thewird
Thread Starter
Joined: Oct 2006
Posts: 6,603
Likes: 15
From: Toronto, Canada
Good news, I found a place for almost half the cost then VP Racing Fuels...
Comet Chemical Company Ltd...
205 liter Drum - $164 + $65 refundable drum deposit
$0.80 /liter
18 liter Pail - $35
$1.95 /liter
The purity of the Methanol is 99.85% minimum.
thewird
Comet Chemical Company Ltd...
205 liter Drum - $164 + $65 refundable drum deposit
$0.80 /liter
18 liter Pail - $35
$1.95 /liter
The purity of the Methanol is 99.85% minimum.
thewird
Thread Starter
Joined: Oct 2006
Posts: 6,603
Likes: 15
From: Toronto, Canada
thewird
Thread Starter
Joined: Oct 2006
Posts: 6,603
Likes: 15
From: Toronto, Canada
Canadian Tire. For the quantity we require, its just easier to buy from CT. Storing opened Methanol would just absorb water and ruin the purity.
thewird
thewird
Last edited by thewird; May 1, 2015 at 11:17 PM.
CT had a super special on them last week. Worth to buy at CT any day if not, just pick up the windscreen washer fluid. I find the green fluid works nicer due to lower freezing point because it has more methyl inside. Then again, blue is good as its available everywhere.
Joined: Sep 2005
Posts: 25,581
Likes: 136
From: Smiths Falls.(near Ottawa!.Mapquest IT!)
I only know where to get good Crack..
Sorry..not into Meth...!!
(no wonder that 3 rotor is fast Marco..lol!)
*remember kids..don't do drugs.
Sorry..not into Meth...!!
(no wonder that 3 rotor is fast Marco..lol!)
*remember kids..don't do drugs.
I have not seen a meth pump/controller setup that recommends anything other than a 50/50 mix for various safety and equipment reliability concerns.
I never actually measure out 50/50, it's always approximate. My R32 @ 25psi is putting down 610 awhp and I have not had any issues with my less than precise mixing habits.
This is based on ~5 years with the AEM v1 and v2 setups on a 1990 R32 with a Borg Warner T4 single.
I do by my jugs at CT too, but need to find another source. They are @ $10:29 for a gallon now and I use a half jug (full meth tank @ ~50/50) with every gas tank.
Just thought I would share my experience so far.
Menace
__________________
\_________________/
(OO)\_____GTR /(OO)
Last edited by can-menace; May 17, 2015 at 04:24 AM.
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
Oct 9, 2015 10:05 PM
Cameron38
1st Gen General Discussion
2
Sep 19, 2015 11:45 PM




